TTi Performance Exhaust & Headers

Tube Technologies, Inc

1555 Consumer Circle

Corona, CA 92880-1726

Phone (951)371-4878   Fax (951)371-6143

PHONE:  951-371-4878

PHONE HOURS:  8am-4pm

Mon-Fri (Pacific Time)

 

HOMEAUTHORIZED DISTRIBUTORS

 

Footnote refers to a specific part or application

Footnote #C2

 

Ceramic Coated (exterior)

A silver matte finish applied to the steel surface to protect against rust, corrosion and withstands temperatures up to 1200F.  Exceeding this temperature will result in discoloration of the tubes coming out of the ports.

 

Note:  Exhaust corrosion will occur if moisture (condensation) is not cleared out of the tubes.  Make sure that the vehicle is driven at least 20 to 30 minutes whenever the car is started to completely dry out all liquid / acid that is created by the combustion process in the engine.  Failure to do so will cause pre-mature rotting of the tubes from the inside out.

 

Warning:  First Engine Runs

We strongly suggest that you use an old set of headers or set of cast iron manifolds for your first engine run / cam break-in.  This will insure that you will not damage the coating and void the warranty of your new headers.  Header coating damage usually occurs during the first engine run / break-in when the exhaust temperatures exceed 1200F.  Excess exhaust temperatures are normally caused by excessively rich or lean air / fuel mixtures and / or incorrect ignition timing.

 

2-Year Limited Ceramic Coating Warranty

 

 

 

 

Updated: March 05, 2014